Press R or click the Relative checkbox to toggle relative mode.It is advisable to move the pointer out of the 3D view before entering coordinates. Or you can press the Enter point button when you have the desired values. To manually enter coordinates enter the X, Y and Z component, and press Enter after each.The shortcuts mentioned here are the default shortcuts. The single character keyboard shortcuts available in the task panel can be changed. The displayed angle depends on the edges and the picked point.To position the dimension arc pick a point in the 3D view.Hold down the Alt key, select two straight edges in the 3D view and release the Alt key.Repeat this to select a second straight edge. Press E or the Select edge button and select a first straight edge in the 3D view.Hold down the Shift key and pick a point in the 3D view.Hold down the Alt key, select a circular edge in the 3D view and release the Alt key.Press E or the Select edge button and select a circular edge in the 3D view.Optionally select a circular edge in the 3D view.Move the pointer to the left or right of the edge or points.Hold down the Shift key, move the pointer and pick a point in the 3D view.Move the pointer above or below the edge or points.Pick a point in the 3D view, or type coordinates and press the Enter point button.To position the dimension line do one of the following:.Pick a second point in the 3D view, or type coordinates and press the Enter point button.Pick a first point in the 3D view, or type coordinates and press the Enter point button.Define the measured distance by picking points:.Hold down the Alt key, select a straight edge in the 3D view and release the Alt key.Press E or the Select edge button and select a straight edge in the 3D view.If you have not yet selected an edge do one of the following:.Select the Annotation → Dimension option from the menu.There are several ways to invoke the command:.Optionally select a straight edge in the 3D view.See also: Draft Tray, Draft Snap and Draft Constrain. Linear dimension defined by three points Create But these create dimensions that are only displayed on the drawing page and not in the 3D view. Alternatively the TechDraw Workbench offer its own dimension commands. Angular dimensions are not parametric.ĭraft Dimensions can be displayed on a TechDraw Workbench page using the TechDraw DraftView or TechDraw ArchView commands. Measured edges can belong to Draft objects but also to solid bodies. This means that they will update if the measured edge is modified. Linear dimensions based on edges and radial dimensions are parametric. The command can also be used to convert Std MeasureDistance objects. The Draft Dimension command creates a linear dimension, a radial dimension or an angular dimension.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |